top of page
Ridge Cap
Where metal panels meet at the top of a roof, a ridge cap is used to provide a watertight connection. The same ridge cap trim can also be used as a hip cap.
Eave Trim
The bottom edge of a roof section is protected by eave drip and fascia metal
Valley
Where two slopes meet at a low point, a valley flashing is required to provide a continuous drainage path.
Transition
Transition flashing is used where roof sections change slope.
Rake / Gable
Where the long side of a panel meets the side of the roof section a gable rake trim is used to seal the panel edge.
Sidewall
Sidewall and endwall trims are installed to provide a watertight transition between a wall and roof section.
bottom of page