Trim Pieces
Eave Trim
"Drip Edge"
Eave trim gives a finished look to your roof. It is installed at the roofs edge.
Ridge Cap
Standard
Where metal panels meet at the top of a roof, a ridge cap is used to provide a watertight connection.
Rake Trim
Low Profile
Where the long side of a panel meets the side of the roof section rake trim is used to seal the panel edge.
Rake Trim
High Profile
The bottom edge of a roof section is protected by eave drip and fascia metal
Ridge Cap
Sculptured
Where metal panels meet at the top of a roof, a ridge cap is used to provide a watertight connection.
Transition
Low Profile
Transitions are used to change the slope or when a roof transitions to a porch.
Endwall
"Wall Flashing"
Used when panels run against a perpendicular wall.
Sidewall
Low Profile
Used when panels run against a parallel wall or chimney.
Sidewall
High Profile
Used when panels run against a parallel wall or chimney.
Valley
"Wall Flashing"
Valley trim gets installed under roof panels that meet to form a valley. This trim will help properly channel water off the roof.
Corner
Low Profile
Used for corners on a metal building & on the gable ends of commercial buildings.
Corner
High Profile
Used for corners on a metal building & on the gable ends of commercial buildings.
Rake Trim
7/8" Corrugated
Used as gable trim for a 7/8" Corrugated metal roof.
Header
Low Profile
Used to trim the perimeter of metal roofing panels.
Header
High Profile
Used to trim the perimeter of metal roofing panels.
Peak
"Highside"
Used on the top of a clear story build.
Jamb
Low Profile
Used to trim the perimeter of metal roofing panels.
Jamb
High Profile
Used to trim the perimeter of metal roofing panels.